Residential electricians · Madison, Wisconsin

Panels, chargers and rewires, labeled and permit-ready.

Volt & Anchor Electric upgrades the electrical systems of Madison's older houses: 1950s fuse boxes, crowded 100-amp panels, garages that need a car charger and kitchens that trip every time the toaster and kettle run together. Every circuit is labeled, every permit is pulled, and every apprentice works beside a master.

Wisconsin master electrician on every job.

Truck 14 · 200-amp panel upgrade

Electrician labeling breakers in a freshly installed panel

Permit pulled · rough-in done · inspection Thursday 9:00

Madison electrical credentials

Our checklist

The electrical work we say yes to

We stay inside the houses we know best: single-family homes, duplexes and small shops within forty minutes of the Capitol.

New breaker panel with neatly bundled cables

Panel replacements and service upgrades

Fuse boxes, Federal Pacific and Zinsco panels come out. A new 200-amp panel goes in with room for a heat pump, a charger and the induction range you have been eyeing.

Wall-mounted EV charger beside a garage door

Level 2 EV charger installs

A dedicated 50-amp circuit, a load calculation on your panel and a permit. We install ChargePoint, Wallbox and Tesla wall units in attached and detached garages.

Open plaster wall with new cable fished between studs

Whole-house and partial rewires

Knob-and-tube and cloth-sheathed wiring replaced room by room, fished through plaster walls with the smallest patches the walls allow.

Standby generator outside a home with a transfer switch

Standby generator hookups

Interlock kits and transfer switches that keep the furnace blower and sump pump running when a January ice storm drops the lines.

Warm recessed lighting over a kitchen island

Lighting, recessed cans and dimmers

Cans cut into finished ceilings with IC-rated housings, fixtures hung on the right box and dimmers matched to the LED you bought.

Outlet tester showing a correctly wired receptacle

Safety upgrades and inspections

GFCI and AFCI protection, smoke and CO interconnects, and a written report before you list or buy a home.

Posted prices for the jobs people ask about

These are typical installed prices for a standard Madison house. Anything unusual is quoted in writing at the visit.

Members pay about 20% less

Troubleshoot and repair

First hour of diagnosis for dead outlets, tripping breakers or flickering lights.

$185 flat

  • Thermal scan of the panel
  • Repair priced before work
  • Parts at wholesale cost
Book a repair
Most booked

200-amp panel upgrade

New panel, meter socket and grounding, with utility coordination through MGE.

$3,950 flat

  • Permit and inspection included
  • Labeled circuit directory
  • Surge protector installed
Quote my panel

Level 2 EV charger

Wall unit mounted within thirty feet of the panel on a new dedicated circuit.

$1,450 flat

  • Load calculation
  • Wi-Fi setup and app pairing
  • Focus on Energy rebate paperwork
Add a charger

Numbers from the inspection log

Panels upgraded in Dane County
1,260
Pass city inspection on the first try
96%
Master electricians on the roster
5
Callback window on any warranty issue
24 hr

Panels, garages and old walls

Recent installs photographed before the drywall closed.

Who is under the truck number

Everyone on the roster holds a Wisconsin license, and the crew trains every winter on the new National Electrical Code cycle.

  • Nora HaugenOwner and master electrician, 22 years in the trade
  • Calvin BrandtLead electrician for EV charging and solar-ready panels
  • Dee RamirezService coordinator who books every visit and permit
  • Owen PikeThird-year apprentice, enrolled in the state program

Straight answers on household electricity

How do I know if my panel is unsafe?

Fuse boxes, Federal Pacific Stab-Lok and Zinsco panels, scorch marks, a buzzing sound and breakers that will not reset are all reasons to call. We inspect and write up findings whether you hire us or not.

Will the power be off all day for a panel swap?

Plan for six to eight hours. We coordinate the utility disconnect, bring a temporary power strip for the fridge and restore every circuit before we leave.

Can my panel handle a car charger?

We run a load calculation, not a guess. If the panel is short, we tell you whether a load manager, a smaller charger or a service upgrade is cheapest.

Do you pull permits yourselves?

Yes. The city of Madison and neighboring Dane County towns each get their own permit, and the inspection cards come home in your folder.

Can I use a handyman for outlets?

Wisconsin requires a licensed electrician for most permanent wiring. Unlicensed work can void insurance, and we have rewired plenty of it.

Give your panel a second opinion

Send photos of the panel door and we will tell you what we see, free, within one business day.

Upgrade request

Tell us what the house needs

The more we know before the visit, the fewer return trips. A coordinator replies the same business day.

Photo of your panel (optional)